Go Back   MBClub UK - Bringing together Mercedes Enthusiasts > Technical > Interior
MBClub supports BEN Official Stickers @mbclubuk


Interior Seats, upholstery, steering wheels and trim

Like Tree2Likes
  • 1 Post By geek
  • 1 Post By snaillybob
Reply
 
Thread Tools
Old 30-08-2015, 08:42 AM   #1
Member
 
geek's Avatar
 
Join Date: Apr 2003
Location: In the countryside
Car: 2011 W221 S350
Posts: 87
W221 Door Trim Removal

Hi,

Can anyone advise how to take the wooden door trim parts off the front doors of a W221 S Class. Its the wooden strip that has the ambient lighting beneath it. Both the drivers and passenger side rattle.

Thanks in advance.
snaillybob likes this.
geek is offline   Reply With Quote
Old 13-10-2016, 10:28 PM   #2
New Member
 
Join Date: Oct 2016
Car: W221 S Class (2012)
Posts: 2
Hi,

Looking for the same advice - same problem. Had read elsewhere that the wood trim is held on with 'spire type fixings' - anyone know if these are captive? Would hate to prise the trim off only to hear the tinkle of the fasteners falling down inside the door card!!

Am intending using some adhesive acoustic tape on the back of the trim and refitting. Sound like a plan to cure the rattle?
snaillybob is offline   Reply With Quote
Sponsored Links
Old 14-10-2016, 09:59 AM   #3
Hardcore MB Enthusiast
 
Join Date: Mar 2015
Location: Essex
Car: s320
Posts: 871
Would not mind finding out how the door trim and card comes off either.
zipdip is offline   Reply With Quote
Old 15-10-2016, 07:12 PM   #4
New Member
 
Join Date: Oct 2016
Car: W221 S Class (2012)
Posts: 2
OK - so took the plunge today with the help of a friend to hold the removed panel. Remove tweeter grille by gently popping off, then 2 screws - one under the front of the armrest (plastic cover) and one in the armrest (open the lid - at the back - feel a square through the felt and remove upwards). Used a spluger to pop the clips and the door panel then lifts up (pull straight up to release from the plastic channel that holds the top of the panel on). The wood trim is held on by screws (6 of them - all torx) - they were all tight. Removed them and released the wood trim. Be careful with the LED lighting ribbon. Added a smallish rectangle of self adhesive acoustic felt to front and back of the LED connector, and a tiny bit to the front end of the LED strip as there was a potential for rattling. Whilst the panel was off I wrapped some of the wire looms in acoustic felt where they ran across the metal of the inner door. Re-assembled - you'll find that getting the top of the panel back into the top channel is a faff - make sure you don't trap the rubber finishing seal when putting the door back on.

So - did it make a difference? Yes and no - it got rid of a mid range frequency rattle, but the higher range one required a thin strip of acoustic foam wrapped around the tweeter before popping it back in its housing (there was a lot of movement with the tweeter before this), and the bass (has to be really loud deep bass) was only cured by wrapping acoustic foam along the lip of the top of the door panel and forcing it back into the plastic channel (door panel had to come off again for this).

So - a couple of design flaws with the tweeter housing and the way in which the top of the door panel fits into the holding channel, but with an amazon purchase of some self adhesive acoustic tape and a set of door panel removal tools, and some torx 'rods', oh, and a friend to hold the door panel it's achievable in about an hour. Passenger door next!!!
A250 Bennyboy likes this.

Last edited by snaillybob; 15-10-2016 at 07:12 PM. Reason: typo's
snaillybob is offline   Reply With Quote
The Following User Says Thank You to snaillybob For This Useful Post:
JohnEBoy (15-10-2016)
Reply

Tags
door, removal, trim, w221


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools



All times are GMT +1. The time now is 12:42 PM.


MB club UK is A Mercedes Enthusiast club run by enthusiasts for enthusiasts, MBClub UK is in no way affiliated with Mercedes-Benz, DaimlerChrysler or any of their respective trademarks. The posted views of our members are in no way the views of MBClub.co.uk or its owners.
Find us on Google+